Outlets

  • Avoid overloading outlets and circuits.
  • Consider installing ground fault circuit interrupters (GFCI) in areas that may be exposed to water.
  • GFCI protection helps reduce the risk of electrical shock and should be installed where required by applicable electrical codes. If you are unsure whether your home has adequate GFCI protection, contact a licensed electrician.
  • Utilize outlet covers when outlets are not in use, especially if young children are in the home.

Electricity & Water

  • Do not use corded power tools in wet or damp conditions or while standing in water, unless the equipment is specifically designed, rated and used for those conditions.
  • Do not touch plugged-in electrical appliances or equipment while in contact with water.

Appliances & Cords

  • When practical, unplug small appliances that are not in use or before extended travel, following the manufacturer’s instructions.
  • Periodically check accessible outlets, plugs, cords, and electrical equipment for visible damage. Contact a qualified electrician if damage, overheating, repeated breaker trips, or other concerns are observed.
  • Do not use electrical equipment with frayed, cracked, exposed or otherwise damaged cords or plugs; remove it from service until properly repaired or replaced.
  • Do not route electrical cords under rugs or carpeting, where damage or overheating may go unnoticed.
  • Handle electrical appliances and tools with dry hands and use them only as directed by the manufacturer.

Power Issues

  • If you regularly reset breakers, have lights that flicker, replace fuses, see sparks, etc., it is best to contact an electrical contractor to perform an inspection and make any repairs, if necessary.
  • In the state of Colorado, electricians are unable to pull your meter without prior notice to CORE. If you are aware of work that needs to be completed and the meter is to be pulled, ensure your electrician first contacts CORE.
  • If your meter has been pulled for six months or longer — or 12-plus months for an irrigation account — you must have an inspection completed prior to reconnection of your service.